Haunted House Update 2

Today I managed to clean the house up quite a bit. I removed a lot of branches and other things that were obstructing the view of the house by copying/pasting sections of the house, as well as by using the healing brush tool and paintbrush. Next class I will finish up the last bits that need to be fixed and begin to look for backgrounds and foregrounds I can use to establish the setting of the house.

Haunted House Update 1

Today I cropped out the house as well as started to remove the pole/wire on the right side of the house that is attached . I'm going to use other parts of the house to reconstruct it.

Final - Spider-Doo

Finally, I'm done with Spider-Doo! Hopefully the quality of the image isn't too bad.
The final steps I took after putting on Scooby's face, coloring it, and stealing the webbing from Spiderman's face and warping/liquifying it were to color it. I colored in the webbing to make it more natural and at times I even painted on my own webbing rather than copying and pasting it. I matched the webbing using the surrounding areas, paying attention to where the light would be shining. One trouble I had was deciding what to do around the mouth since it is so wide and goes to the left pretty far down Scooby's face. I originally had the webbing go over it but I decided to work the webbing to go around it. Overall, I feel like I did a decent job.

Spider-Doo Update 4

I have shaped the webbing to Scooby's face and replaced the gap where Spiderman's eye originally was. At this point, it's time to get down the shading correctly, which I've already partly done. A little more touch ups and soon it should be done!

Spider-Doo Update 3

Now I am beginning to fit the webbing to Scooby's face. I warped and masked the webbing to get the general fit that I want down. Next I'm going to liquify it as well for more specific changes. After I get the shape of it down I will need to reconstruct the open space where Spiderman's eye originally was.

Haunted House

Here are a few houses that I would like to transform into a haunted house. I like the peaks and pointy parts of them and they would fit for a good looking and ancient haunted house. I like the 2nd and 5th ones the best. The other ones are decent too but they just don't have that certain feel that I'm looking for.

Spider-Doo Update 2

Cutting out the webbing of the face:

Spider-Doo Update 1

Last class I got up to this point. I cut out the head of Scooby-Doo and positioned it to fit on Spiderman's body and over his head (I had to warp the original Spiderman's head so that it would be completely covered by Scooby's). I also altered the hue/saturation of the fur so that the color of the head matched the body.
Now I'm going to start on the webbing covering the face.